Aircraft Spruce and Specialty Co Forum Index Aircraft Spruce and Specialty Co
The Pilots Portal to the World
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Flying wire fitting thickness?

 
Post new topic   Reply to topic    Aircraft Spruce and Specialty Co Forum Index -> Starduster and Acroduster
View previous topic :: View next topic  
Author Message
Bob E.



Joined: 31 Oct 2007
Posts: 147
Location: Central ND

PostPosted: Sun Aug 07, 2011 12:25 pm    Post subject: Flying wire fitting thickness? Reply with quote

I have my flat fittings to make so I can measure for my flying wires to get them ordered and noticed there is no material thickness given (or that I have found) on the plans, sheet 15, part number 148. This is the flat tab that goes on each lower longeron between the firewall and engine mount. SD TOO btw.

I'm thinking .095 but not sure.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Aircraft Spruce and Specialty Co Forum Index -> Starduster and Acroduster All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by Aircraft Spruce Worldwide Distributor of Certified and Homebuilt Aircraft Supplies